The Assurance You Need

Our Assurance®, Ambidex® and ProCoat® lines of chemical and liquid resistant gloves have been designed with the utmost safety in mind. Resistance and permeation test results are available for a wide variety of chemical families found commonly in the workplace. While these results are generated in a laboratory setting and we are highly confident of the ability to perform well at work, we recommend that you should also conduct your own testing to make certain that the gloves are compatible with your application.

SHOWING 1-1 OF 1 ITEMS
1 of 1
FILTERS:
CLEAR ALL
NEW PRODUCTS
Nitrile Coated with MicroFinish Grip NEW

Assurance®

Nitrile Coated Glove with PolyKor® Blended Liner and MicroFinish Grip on Palm & Fingers - 14"

56-586CR

  • Supported Nitrile with MicroFinish Grip
  • Gray Polykor cut resistant liner
  • 14" length.
  • SIZES: XS-2XL
  • PACKED: 6 Dozen/Case
  • STOCK TYPE: Stock
    Made to Order (56-586CR/XS)
ansi-A4
ANSI Cut Level: A4

Test Method: ASTM F2992-15

New edition ANSI/ISEA 105-2016 outlines a new test method for determining cut scores and a revised scale from A1-A9. Click here for more information about the new testing standard.

4X42D

EN 388 2016 Results: 4X42DX

Abrasion: 4
Cut (Coupe Test): X
Tear: 4
Puncture: 2
Cut (TDM-100 Test): D
Impact Protection: X

EN 388 is a European Standard. Cut Level is determined by the number of cycles it takes a spinning circular blade, that is pulled across the material under a constant weight of 500 grams, to cut the fabric. As the number of cycles increase, so does the glove's ratings. Click here for more information about the EN 388 2016 standard.

ansi-abrasion-6
ANSI Abrasion Level: 6

Test Method: ASTM D3884-09

The ANSI/ISEA 105-2016 standard outlines test methods for abrasion and is scored from 0-6. The ASTM D3884-09 is used for uncoated gloves and the end point (failure) is the number of abrasion cycles when the first thread or yarn is broken. The larger numbers of cycles indicates greater abrasion resistance of the product and a higher ANSI Abrasion Level.

ANSI Puncture Level: 3

Test Method: ASTM F1342

The ANSI/ISEA 105-2016 blunt force puncture testing uses a probe to simulate a tear or burst hazard. The test measures the amount of force needed for a blunt probe to pierce through PPE material. Results are given in Newtons, which is converted into a 1-5 scale and spans from 10 newtons (Level 1) to 150+ newtons (Level 5) of puncture resistance.

Protective Gloves Against Micro-organisms

The EN ISO 374-5 standard measures the ability of gloves to protect users against bacteria and fungi. Gloves with this marking must pass EN374-2 for leak testing.

Compare
SHOWING 1-1 OF 1 ITEMS
1 of 1
pin Rep Finder
Compare ()
Clear All Compare
Okay, Got it.
X

ORDER SAMPLE

X

GET FIELD TRIAL